This is an IoT operating system for the Raspberry Pi which supports interfaces such as the Waveshare LoRaWAN Gateway Hat.

Guide

Download page

Pi 2B, 3B, 4B

BalenaEtcher is recommended to be used from Windows, else use `dd' in Linux.

A Pi with built-in WiFi will have an access point enabled and this AP will use the IPv4 address range 192.168.0.0/24

If this IP address range conflicts with the local LAN, login to via WiFI and change the network using the web interface and afterward attach an ethernet lead.

The O/S will assign itself a LAN address via DHCP. If you know the MAC address you can use that in advance to setup a fixed IP address.

It also disabled the dnsmasq DHCP authoritative setting.

Under chirpstack enable concentratord, in my case the settings are enable SX1302/SX1303 and then select the Waveshare device on the SX1302/SX1303 tab.

Now enable MQTT forwarding and the gateway is up and running and the chirpstack application can now be configured.