Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tools:tasmota [2023/10/16 20:56] – [SONOFF 4CH PRO R2] darron | tools:tasmota [2023/12/15 07:56] (current) – [SONOFF 4CH PRO R2] darron | ||
---|---|---|---|
Line 352: | Line 352: | ||
===SONOFF 4CH PRO R2=== | ===SONOFF 4CH PRO R2=== | ||
- | First attach a console to the ESP8285. Connect a UART adapter in 3V mode to the Rx/Tx and GND pins on the board and power on with the DC input. | + | <wrap right> |
+ | {{tools: | ||
+ | </ | ||
The built-in firmware for this device died after 6 months of use. The console shows the chip rebooting with watchdog reset errors continuously. | The built-in firmware for this device died after 6 months of use. The console shows the chip rebooting with watchdog reset errors continuously. | ||
+ | |||
+ | To upgrade attach a console to the ESP8285 by connecting a UART adapter in 3V mode to the Rx/Tx and GND pins on the board. Power up with the DC input. | ||
To enable flash erase/ | To enable flash erase/ | ||
Line 360: | Line 364: | ||
==Write flash== | ==Write flash== | ||
- | Writing was unreliable and needed | + | Writing was unreliable and needed |
< | < | ||
- | One write succeeded but subsequent writes have failed | + | esptool.py write_flash 0 tasmota.bin --no-compress |
+ | esptool.py v4.6.2 | ||
+ | Loaded custom configuration from / | ||
+ | Found 1 serial ports | ||
+ | Serial port / | ||
+ | Connecting... | ||
+ | Detecting chip type... Unsupported detection protocol, switching | ||
+ | Connecting... | ||
+ | Detecting chip type... ESP8266 | ||
+ | Chip is ESP8285N08 | ||
+ | Features: WiFi, Embedded Flash | ||
+ | Crystal is 26MHz | ||
+ | MAC: 84: | ||
+ | Stub is already running. No upload is necessary. | ||
+ | Configuring flash size... | ||
+ | Flash will be erased from 0x00000000 to 0x0009efff... | ||
+ | Wrote 655360 bytes at 0x00000000 in 59.9 seconds (87.5 kbit/ | ||
+ | Hash of data verified. | ||
+ | |||
+ | Leaving... | ||
+ | Hard resetting via RTS pin... | ||
</ | </ | ||
==Boot== | ==Boot== | ||
+ | |||
+ | When writing succeeded, this was the boot message. | ||
< | < | ||
Line 393: | Line 419: | ||
[[https:// | [[https:// | ||
+ | |||
+ | {{tools: | ||
+ |