Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| tools:segger [2022/12/12 09:58] – [Test] darron | tools:segger [2024/08/12 12:55] (current) – [Install] darron | ||
|---|---|---|---|
| Line 20: | Line 20: | ||
| ==Raspberry Pi== | ==Raspberry Pi== | ||
| - | J-Link doesn' | + | J-Link doesn' |
| - | run it on arm6l it will crash with a segmentation fault. | + | run J-Link |
| - | Visit the [[https:// | + | Download |
| - | and agree to their terms, after which you may download the armv7l compatible binary and store in /opt. | + | |
| + | [[https:// | ||
| + | |||
| + | [[https://www.segger.com/ | ||
| < | < | ||
| Line 32: | Line 35: | ||
| ln -s JLink_Linux_V782a_arm JLink | ln -s JLink_Linux_V782a_arm JLink | ||
| apt install libsm6 | apt install libsm6 | ||
| - | echo "/opt/JLink/" >> / | + | cp / |
| - | ldconfig | + | |
| - | cp / | + | |
| udevadm control --reload-rules | udevadm control --reload-rules | ||
| udevadm trigger | udevadm trigger | ||
| Line 40: | Line 41: | ||
| The udev rules didn't work for me so I use my [[http:// | The udev rules didn't work for me so I use my [[http:// | ||
| + | |||
| + | NB do not add /opt/JLink to ldconfig path since on ARM64 a 32-bit library will be | ||
| + | included which breaks JLink. | ||
| ===Windows=== | ===Windows=== | ||
| Line 62: | Line 66: | ||
| This board has had ST-Link replaced by JLink on-board. | This board has had ST-Link replaced by JLink on-board. | ||
| + | |||
| + | Upgrading to JLink requires an older ST-LINK firmware to be | ||
| + | installed as newer versions fail to be detected. A working | ||
| + | firmware for upgrade is found in " | ||
| < | < | ||
