Differences

This shows you the differences between two versions of the page.

--- tools:chirpstackos [2024/08/14 16:48] – [Setup] darron
+++ tools:chirpstackos [2024/08/15 13:35] (current) – [Network] darron
@@ Line 1: / Line 1: @@
-====Chirpstack Gateway OS====
+====ChirpStack Gateway OS====
+<wrap right>
+{{:tools:cstack1.jpg?100}}
+\\ \\
+{{:tools:cstack2.jpg?100}}
+\\ \\
+{{:tools:cstack3.jpg?100}}
+</wrap>
 This is an IoT operating system for the Raspberry Pi which supports
@@ Line 26: / Line 34: @@
 use the IPv4 address range 192.168.0.0/24
-If this IP address range conflicts with the local LAN, login via WiFI and change
+If this IP address range conflicts with the local LAN, login to via WiFI and change
-the network and afterward attach an ethernet lead.
+the network using the web interface and afterward attach an ethernet lead.
 The O/S will assign itself a LAN address via DHCP. If you know the MAC address
 you can use that in advance to setup a fixed IP address.
+Ensure that ignore interface is set for DHCP on the LAN. There should be no
+harm disabling dnsmasq authoritative DHCP for the LAN as well.
+===ChirpStack===
+Under ChirpStack enable concentratord, in my case I enabled SX1302/SX1303
+and then selected the Waveshare device on the SX1302/SX1303 tab.
+Now enable MQTT forwarding and the gateway is up and running and the ChirpStack server
+application can now be configured.