You are here: start » tools » chirpstackos

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
tools:chirpstackos [2024/08/14 16:47] – [Programming] darrontools:chirpstackos [2024/08/15 13:35] (current) – [Network] darron
Line 1: Line 1:
-====Chirpstack Gateway OS====+====ChirpStack Gateway OS==== 
 + 
 +<wrap right> 
 +{{:tools:cstack1.jpg?100}} 
 +\\ \\ 
 +{{:tools:cstack2.jpg?100}} 
 +\\ \\ 
 +{{:tools:cstack3.jpg?100}} 
 +</wrap>
  
 This is an IoT operating system for the Raspberry Pi which supports This is an IoT operating system for the Raspberry Pi which supports
Line 21: Line 29:
 [[https://etcher.balena.io/|BalenaEtcher]] is recommended to be used from Windows, else use `dd' in Linux. [[https://etcher.balena.io/|BalenaEtcher]] is recommended to be used from Windows, else use `dd' in Linux.
  
-===Setup===+===Network===
  
 A Pi with built-in WiFi will have an access point enabled and this AP will A Pi with built-in WiFi will have an access point enabled and this AP will
 use the IPv4 address range 192.168.0.0/24 use the IPv4 address range 192.168.0.0/24
  
-If this IP address range conflicts with the local LAN, login via WiFI and change +If this IP address range conflicts with the local LAN, login to via WiFI and change 
-the network and afterward attach an ethernet lead.+the network using the web interface and afterward attach an ethernet lead.
  
 The O/S will assign itself a LAN address via DHCP. If you know the MAC address The O/S will assign itself a LAN address via DHCP. If you know the MAC address
 you can use that in advance to setup a fixed IP address. you can use that in advance to setup a fixed IP address.
 +
 +Ensure that ignore interface is set for DHCP on the LAN. There should be no
 +harm disabling dnsmasq authoritative DHCP for the LAN as well.
 +
 +===ChirpStack===
 +
 +Under ChirpStack enable concentratord, in my case I enabled SX1302/SX1303
 +and then selected the Waveshare device on the SX1302/SX1303 tab.
 +
 +Now enable MQTT forwarding and the gateway is up and running and the ChirpStack server
 +application can now be configured.
 +