Mindy is a port of Mork which in turn is an adaptation of Nanu nanu Microchip PIC32MX ICSP. This time Mindy is for PIC32 based boards such as the chipKIT Pi and the SDXL.

Mork is licensed under same terms as Pickle Microchip PIC ICSP which is the source of the software used to create this project. The Pickle LICENCE is found here. This licence details the rights and liabilities of using the application and it should be especially understood that I, the author, will not accept any responsibility for any side effects of running it. Do not download and use this firmware unless you are willing to accept the consequences of it failing for any reason.

This software was written by Darron M Broad and is an adaptation of Pickle Microchip PIC ICSP.

Thanks go to Alan Ott and Signal 11 software who wrote m-stack, the PIC micro USB stack used by this application.

First install the MPIDE compiler.

Fetch the source and build.

hg clone http://hg.kewl.org/pub/Mindy
cd Mindy
make

If you have a chipKIT Pi, you can program the firmware like this. Remember to enter bootload mode with the buttons.

make -f Makefile.mx250_ckpi program

For the MX270 on the chipKIT Pi, it's almost the same.

make -f Makefile.mx270_ckpi program

If you have a SDXL do this.

make -f Makefile.sdxl program

If the above fail to install, then you probably need Pickle for the loader utility. If you prefer, you can use PIC32Prog and just select the correct hex file and interface.

For the chipKIT Pi the connections are as follows.

On the SDXL, RB0 (A10) = PGC, RB1 (A11) = VPP, RB2 (A12) = PGD

In this example, PIC32Prog is used to program a chip. This application also works in Windows if necessary.

pic32prog -S -d /dev/ttyACM0 mx150.hex
Programmer for Microchip PIC32 microcontrollers, Version 2.0.9986ac0
    Copyright: (C) 2011-2015 Serge Vakulenko
      Adapter: STK500v2 Bootloader
 Program area: 1d000000-1d07ffff
    Processor: Bootloader
 Flash memory: 512 kbytes
  Boot memory: 12 kbytes
         Data: 55500 bytes
        Erase: done
Program flash: ######################################################### done
 Program boot: ### done      
Rate: 23799 bytes per second

pic32prog -v -d /dev/ttyACM0 mx150.hex
Programmer for Microchip PIC32 microcontrollers, Version 2.0.9986ac0
    Copyright: (C) 2011-2015 Serge Vakulenko
      Adapter: STK500v2 Bootloader
 Program area: 1d000000-1d07ffff
    Processor: Bootloader
 Flash memory: 512 kbytes
  Boot memory: 12 kbytes
         Data: 55500 bytes
 Verify flash: ######################################################## done
  Verify boot: ## done       
Rate: 27165 bytes per second