Easy-loader uploads application hex files to either the Cowboy boot loader for enhanced PIC12/PIC16, Wellington boot loader for PIC18 or Oxford boot loader for dsPIC/PIC24.

Easy-loader also has a number of options to interrogate the boot loader to inspect chip flash and EEPROM content.

Easy-loader is installed from source.

hg clone http://hg.kewl.org/pub/easy-loader
cd easy-loader
make
sudo make install

Typing easy-loader alone will output the following help.

USAGE: easy-loader [OPTIONS] DEVICE [HEX-FILE]

Invalid args.

Options:
 -a   arduino (DTR + CAP) reset
 -b N use TTY baud rate N
 -d   hang up DTR after serial port open
 -e   read EEPROM
 -f   read flash
 -h   HELLO only
 -i N use CAN bus message id N
 -k N send BRK for N ms after serial port open
 -l   log serial input to stdout when done
 -n   do not run firmware on exit
 -p   run pickle pctrl to reset device
 -q   quiet erase/write
 -r   hang up RTS after serial port open
 -s   simulate erase/write
 -t   time to wait in ms after serial port open
 -v   verify
 -w N winklepicker mode N (1 or 2) reset
 -x   drain serial output after each transmitted byte
 -z A erase page at address A

Version: 4

The device can either be a serial interface of CAN Bus interface. Support for CAN Bus is platform and boot loader dependent and is only available for Linux and the Wellington boot loader at present.

Here a device attached to RPi is first reset using `pctrl restore' and the a hex file image is uploaded at 57600 baud.

easy-loader -p -b 57600 /dev/ttyAMA0 myapp.hex