Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
boards:wio-e5 [2024/08/30 18:37] – [Pinout] darron | boards:wio-e5 [2024/09/17 17:06] (current) – [LoRaWAN firmware] darron | ||
---|---|---|---|
Line 9: | Line 9: | ||
</ | </ | ||
- | This board has a package containing a STM32WLE5JC | + | This board has a package containing a STM32WLE5JC |
- | The MCU does not contain a FPU, only the mandatory DSP for m4 | + | The MCU does not contain a FPU, only the mandatory DSP for M4 |
cores, but it does have an embedded radio, it appears to be an SX1262. | cores, but it does have an embedded radio, it appears to be an SX1262. | ||
Line 32: | Line 32: | ||
the device may be destroyed." | the device may be destroyed." | ||
- | I probably would not have bothered with this board had I read the above warning beforehand. | ||
- | Who designs a MCU that can self destruct if a bit doesn' | ||
Line 210: | Line 208: | ||
< | < | ||
OFF | OFF | ||
- | RF_SW_CTRL1 = 0 | + | PA4 RF_SW_CTRL1 = 0 |
- | RF_SW_CTRL2 = 0 | + | PA5 RF_SW_CTRL2 = 0 |
RX | RX | ||
- | RF_SW_CTRL1 = 1 | + | PA4 RF_SW_CTRL1 = 1 |
- | RF_SW_CTRL2 = 0 | + | PA5 RF_SW_CTRL2 = 0 |
RFO_LP | RFO_LP | ||
- | RF_SW_CTRL1 = 1 | + | PA4 RF_SW_CTRL1 = 1 |
- | RF_SW_CTRL2 = 1 | + | PA5 RF_SW_CTRL2 = 1 |
RFO_HP | RFO_HP | ||
- | RF_SW_CTRL1 = 0 | + | PA4 RF_SW_CTRL1 = 0 |
- | RF_SW_CTRL2 = 1 | + | PA5 RF_SW_CTRL2 = 1 |
</ | </ | ||
+ | |||
+ | According to the product WIKI RFO_LP is not supported. | ||
===Clock=== | ===Clock=== | ||
Line 236: | Line 236: | ||
32.768KHz | 32.768KHz | ||
+ | |||
+ | ===LoRaWAN firmware=== | ||
+ | |||
+ | The I-CUBE LoRaWAN demo has been updated to support GNU make [[https:// | ||
+ | |||
===Resources=== | ===Resources=== |