You are here: start » boards » wb15

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
boards:wb15 [2024/08/13 12:46] – [Upgrade procedure] darronboards:wb15 [2024/08/15 02:24] (current) – [Demo firmware] darron
Line 123: Line 123:
 pre-enter the firmware start address. pre-enter the firmware start address.
  
-Start addresses from table for stm32wb1x_BLE_Stack_full_fw.bin+Start addresses from the tables for stm32wb1x_BLE_Stack_full_fw.bin
  
 ^Version^Address^ ^Version^Address^
Line 142: Line 142:
 ===Demo firmware=== ===Demo firmware===
  
-To program the device with a user application use the command line utility not the desktop app.+To program the device with a user application you can use the command line utility and not only the desktop app.
  
 A few demos exist for the the Android app named "ST BLE Sensor" A few demos exist for the the Android app named "ST BLE Sensor"
Line 150: Line 150:
 ==Program== ==Program==
  
-A pre-built hex file can be programmed, else the application built from a [[https://wiki.st.com/stm32mcu/wiki/Connectivity:STM32WB_BLE_STM32CubeMX|guide]] for STM32CubeMX.+A pre-built hex file can be programmed, else the application can be built using this [[https://wiki.st.com/stm32mcu/wiki/Connectivity:STM32WB_BLE_STM32CubeMX|guide]] for STM32CubeMX.
  
 +Browse to
 +
 +<code>
 +Projects\NUCLEO-WB15CC\Applications\BLE\BLE_p2pServer\Binary
 +</code>
 +
 +Execute
 <code> <code>
-"/mnt/c/Program Files/STMicroelectronics/STM32Cube/STM32CubeProgrammer/bin/STM32_Programmer_CLI.exe" -c port=SWD reset=HWrst -q -w BLE_p2pServer_reference.hex -v -hardRst+STM32_Programmer_CLI.exe" -c port=SWD reset=HWrst -q -w BLE_p2pServer_reference.hex -v -hardRst
 </code> </code>
  
-The hex file can be found in the Applications directory for the board along with the blobs downloaded above. 
  
 ==Console== ==Console==