Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| boards:wb15 [2024/08/13 12:41] – [Upgrade procedure] darron | boards:wb15 [2024/08/15 02:24] (current) – [Demo firmware] darron | ||
|---|---|---|---|
| Line 104: | Line 104: | ||
| < | < | ||
| - | mkdir -p /mnt/c/ST | + | git clone https:// |
| - | cd /mnt/c/ST | + | |
| - | wget "https:// | + | |
| - | unzip STM32CubeWB-master.zip | + | |
| </ | </ | ||
| Line 114: | Line 111: | ||
| Browse to | Browse to | ||
| < | < | ||
| - | /mnt/c/ST/STM32CubeWB/ | + | STM32CubeWB/ |
| </ | </ | ||
| Line 126: | Line 123: | ||
| pre-enter the firmware start address. | pre-enter the firmware start address. | ||
| - | Start addresses from table for stm32wb1x_BLE_Stack_full_fw.bin | + | Start addresses from the tables |
| ^Version^Address^ | ^Version^Address^ | ||
| Line 145: | Line 142: | ||
| ===Demo firmware=== | ===Demo firmware=== | ||
| - | To program the device with a user application use the command line utility not the desktop app. | + | To program the device with a user application |
| A few demos exist for the the Android app named "ST BLE Sensor" | A few demos exist for the the Android app named "ST BLE Sensor" | ||
| Line 153: | Line 150: | ||
| ==Program== | ==Program== | ||
| - | A pre-built hex file can be programmed, else the application built from a [[https:// | + | A pre-built hex file can be programmed, else the application |
| + | Browse to | ||
| + | |||
| + | < | ||
| + | Projects\NUCLEO-WB15CC\Applications\BLE\BLE_p2pServer\Binary | ||
| + | </ | ||
| + | |||
| + | Execute | ||
| < | < | ||
| - | "/ | + | STM32_Programmer_CLI.exe" |
| </ | </ | ||
| - | The hex file can be found in the Applications directory for the board along with the blobs downloaded above. | ||
| ==Console== | ==Console== | ||
