You are here: start » boards » lrwan1

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
boards:lrwan1 [2024/09/11 10:03] – [Pinout] darronboards:lrwan1 [2024/09/18 13:21] (current) – [LoRaWAN firmware] darron
Line 87: Line 87:
 </code> </code>
  
-==Arduino==+==Arduino host==
 <code> <code>
 I2C I2C
Line 131: Line 131:
 PA4 RF SWITCH CONTROL 1 PA4 RF SWITCH CONTROL 1
 PB8 RF SWITCH CONTROL 2 PB8 RF SWITCH CONTROL 2
- 
-PA4 BATTERY LEVEL 
  
 PB10 LPUART_TX PB10 LPUART_TX
 PB11 LPUART_RX PB11 LPUART_RX
 +
 +PB6 I2C1 SCL
 +PB7 I2C1 SDA
 </code> </code>
  
Line 163: Line 164:
 +JoinAccepted +JoinAccepted
 </code> </code>
- 
-==Custom firmware== 
- 
-[[https://github.com/USIWP1Module/USI_I-NUCLEO-LRWAN1/tree/master/I-CUBE-LRWAN_patchs/I-CUBE-LRWAN%201.2.2|Guide]] 
- 
-It would appear that once the factory default firmware is wiped it cannot 
-be restored, however, the default firmware appears to be buggy in any case. 
  
  
Line 233: Line 227:
 J-Link> J-Link>
 </code> </code>
 +
 +===LoRaWAN firmware===
 +
 +
 +Patches for I-CUBE LoRaWAN 1.2.2 are [[https://github.com/USIWP1Module/USI_I-NUCLEO-LRWAN1/tree/master/I-CUBE-LRWAN_patchs/I-CUBE-LRWAN%201.2.2|here]].
 +
 +The I-CUBE LoRaWAN demo has been already patched and updated to support GNU make [[https://hg.kewl.org/pub/LauraWAN|here]].
 +
 +NB once the factory default firmware is wiped it cannot be restored.
 +
 ===Resources=== ===Resources===