Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
boards:l4p5zg [2024/08/01 12:57] – darron | boards:l4p5zg [2024/11/09 05:23] (current) – [NUCLEO-L4P5ZG] darron | ||
---|---|---|---|
Line 9: | Line 9: | ||
</ | </ | ||
- | This is an STM32 L4+ development board with an STM32L4P5ZGT6U MCU | + | This is an ARM Cortex-M4 |
- | and a USB port. | + | at 120 MHz with 1 MB FLASH and 320 KB RAM. |
- | The L4+ series | + | It has a USB OTG port and L4+ USB is supported by TinyUSB with its dwc2 driver. |
===Pinout=== | ===Pinout=== | ||
Line 18: | Line 18: | ||
< | < | ||
ST-LINK UART | ST-LINK UART | ||
- | PA2 USART2_TX | ||
- | PA3 USART2_RX | ||
PG7 LPUART1_TX AF8 | PG7 LPUART1_TX AF8 | ||
PG8 LPUART1_RX AF8 | PG8 LPUART1_RX AF8 | ||
Line 40: | Line 38: | ||
PA11 USB DM AF10 | PA11 USB DM AF10 | ||
PA12 USB DP AF10 | PA12 USB DP AF10 | ||
- | PG6 USB GPIO OUT | + | PG6 USB GPIO OUTPUT POWER SWITCH |
- | PG5 USB GPIO IN | + | PG5 USB GPIO INPUT OVER-CURRENT ALARM |
</ | </ | ||
Line 53: | Line 51: | ||
[[https:// | [[https:// | ||
+ | |||
+ | [[https:// | ||
[[https:// | [[https:// | ||
[[https:// | [[https:// | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | [[https:// | ||
[[https:// | [[https:// |