Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
boards:l073rz [2024/08/12 11:23] – [Pinout] darron | boards:l073rz [2024/09/10 18:15] (current) – [ST-LINK] darron | ||
---|---|---|---|
Line 1: | Line 1: | ||
====NUCLEO-L073RZ==== | ====NUCLEO-L073RZ==== | ||
+ | |||
+ | 32 MHz STM32L073RZ Cortex-M0+ with 192 KB flash and 20 KB RAM. | ||
<wrap right> | <wrap right> | ||
{{boards: | {{boards: | ||
\\ \\ | \\ \\ | ||
- | {{boards:ardl073rz.jpg?100}} | + | {{boards:l073rz-front.jpg?100}} |
\\ \\ | \\ \\ | ||
{{boards: | {{boards: | ||
+ | \\ \\ | ||
+ | {{boards: | ||
+ | \\ \\ | ||
+ | {{boards: | ||
</ | </ | ||
+ | |||
+ | ===Pinout=== | ||
+ | |||
+ | < | ||
+ | PC10 USART4_TX | ||
+ | PC11 USART4_RX | ||
+ | |||
+ | CN3 STLINK RX | ||
+ | CN3 STLINK TX | ||
+ | </ | ||
===Solder bridges=== | ===Solder bridges=== | ||
Line 17: | Line 33: | ||
SB13 and SB14 ON, SB62 and SB63 OFF | SB13 and SB14 ON, SB62 and SB63 OFF | ||
< | < | ||
- | PA2 ST-LINK | + | PA2 USART2_TX |
- | PA3 ST-LINK | + | PA3 USART2_RX |
</ | </ | ||
- | __Default for NUCLEO-L073RZ with I-NUCLEO-LRWAN1__ | + | __Default for NUCLEO-L073RZ with [[lrwan1|I-NUCLEO-LRWAN1]]__ |
SB13 and SB14 OFF, SB62 and SB63 ON | SB13 and SB14 OFF, SB62 and SB63 ON | ||
< | < | ||
- | PA2 ARD | + | PA2 USART2_TX |
- | PA3 ARD | + | PA3 USART2_RX |
</ | </ | ||
+ | ===ST-LINK=== | ||
+ | By removing the two jumpers at CN2, the ST-LINK interface can be used | ||
+ | to program another board such as the [[lrwan1|I-NUCLEO-LRWAN1]] daughterboard. | ||
+ | |||
+ | |||
+ | < | ||
+ | 1 VDD TARGET | ||
+ | 2 SWCLK | ||
+ | 3 GND | ||
+ | 4 SWDIO | ||
+ | 5 NRST | ||
+ | 6 SWO (RESERVED) | ||
+ | </ | ||
===Resources=== | ===Resources=== | ||
Line 35: | Line 64: | ||
[[https:// | [[https:// | ||
+ | |||
+ | [[https:// | ||
[[https:// | [[https:// |