Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
boards:g491 [2023/08/06 10:13] – [Resources] darron | boards:g491 [2023/11/24 16:39] (current) – [Resources] darron | ||
---|---|---|---|
Line 9: | Line 9: | ||
</ | </ | ||
- | This boards contains a STM32G491xC microcontroller with a top speed of 170 MHz. | + | This boards contains a Cortex M4 STM32G491xC microcontroller with a top speed of 170 MHz. |
- | My first board was programmed twice before LD1 flagged a USB communication failure | + | The MCU has 512 KB of program flash, |
- | whilst in operation | + | |
- | This board also did not work on a USB1.1 hub when it did work. | + | STLINK on this board does not work on a USB1.1 hub. |
- | The target can be programmed via PA13 and PA14 with the STLINK/V3 held in reset | + | The target can be programmed |
- | with JP1 and power set to 5V charger | + | the STLINK/V3 held in reset with JP1 and power set to 5V charger. |
- | + | ||
- | A replacement board appears to work but unproven to be reliable as yet and openocd | + | |
- | can have problems resetting the CPU. | + | |
=== Pinout === | === Pinout === | ||
Line 142: | Line 138: | ||
[[https:// | [[https:// | ||
- | |||
- | [[https:// | ||
[[https:// | [[https:// | ||
[[https:// | [[https:// | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | [[https:// | ||
[[https:// | [[https:// | ||
+ | |||
+ | [[https:// | ||
[[https:// | [[https:// |