Differences

This shows you the differences between two versions of the page.

--- boards:demov1 [2022/11/13 13:29] – darron
+++ boards:demov1 [2022/11/21 13:48] (current) – darron
@@ Line 5: / Line 5: @@
 {{:boards:demov1-test.jpg?200|J-Link test with J-Link EDU Mini}}
 \\ \\
-{{:boards:demov1-test2.jpg?200|OpenOCD test with J-Link CLONE}}
+{{:boards:demov1-test3.jpg?200|OpenOCD test with J-Link CLONE}}
 \\ \\
 {{boards:stm32f030.png?200|Pinout}}
@@ Line 53: / Line 53: @@
 SPI1 MISO PA6
 SPI1 MOSI PA7
+</code>
+===Clocks===
+<code>
+HSE 8000000 X1 8MHz
+HSI 8000000
+LSE 0       N/A
+LSI 32768
 </code>
@@ Line 67: / Line 76: @@
 pin and provide a pulse for testing STM32 EXTI.
-For programming, use [[tools:segger|J-Link]] device or [[tools:openocd|OpenOCD]].
+For programming, use [[tools:segger|J-Link]] or [[tools:openocd|OpenOCD]].
 ==Wiring==
@@ Line 98: / Line 107: @@
 From the RS232 perspective RTS is inverted so when picocom takes
-the line is low, it's actually a high logical output and the board
+the line low, it's actually a high logical output and the board
 is taken out of reset.
 ==Reset==
-CTRL A CTRL G will toggle the RTS line state.
+Picocom CTRL A CTRL G will toggle the RTS line state.
 ==Reboot==
@@ Line 116: / Line 125: @@
 ==Pulse==
-CTRL A CTRL P will pulse the DTR pin from low to high for
+Picocom CTRL A CTRL P will pulse the DTR pin from low to high for
 second to test EXTI high or low edge.