Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| boards:chipkitpi [2015/03/11 11:35] – [Boot loader] darron | boards:chipkitpi [2020/08/05 19:05] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ==== ChipKIT Pi ==== | ==== ChipKIT Pi ==== | ||
| <wrap right> | <wrap right> | ||
| - | {{: | + | {{: |
| + | \\ \\ | ||
| + | {{: | ||
| </ | </ | ||
| Line 7: | Line 9: | ||
| It is designed to be used with the | It is designed to be used with the | ||
| - | [[:boards: | + | [[:tools: |
| + | |||
| + | === RPi GPIO header == | ||
| - | === RPi GPIO header (RPi-Connect) === | ||
| < | < | ||
| + | RPi-Connect | ||
| JP5 | JP5 | ||
| +---J4---+ | +---J4---+ | ||
| - | NC 01 02 GPIO0/ | + | NC 01 02 GPIO0/GPIO2/SDA |
| - | GPIO1/ | + | GPIO1/GPIO3/SCL 03 04 NC |
| GPIO4 | GPIO4 | ||
| GPIO18 | GPIO18 | ||
| Line 27: | Line 31: | ||
| </ | </ | ||
| - | === I/O headers | + | === PIC32 GPIO headers === |
| < | < | ||
| + | Arduino 3V3 compatible | ||
| JA1 | JA1 | ||
| === | === | ||
| Line 52: | Line 58: | ||
| </ | </ | ||
| - | === LED/ | + | === LED === |
| < | < | ||
| LED | LED | ||
| Line 61: | Line 67: | ||
| RX1 | RX1 | ||
| TX1 | TX1 | ||
| + | </ | ||
| + | === Switch === | ||
| + | < | ||
| SW PIC32MX250F128B | SW PIC32MX250F128B | ||
| == =============== | == =============== | ||
| BOOTLOAD-EN | BOOTLOAD-EN | ||
| RESET | RESET | ||
| + | </ | ||
| + | === JTAG === | ||
| + | < | ||
| JTAG PIC32MX250128B | JTAG PIC32MX250128B | ||
| ==== ============== | ==== ============== | ||
| Line 73: | Line 85: | ||
| 2 | 2 | ||
| </ | </ | ||
| - | Orientation is ICSP port to the left and JTAG port to the right. | ||
| === ICSP === | === ICSP === | ||
| Line 93: | Line 104: | ||
| The process is documented on the [[: | The process is documented on the [[: | ||
| + | |||
| + | |||
| + | === Resources === | ||
| + | [[https:// | ||
