Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| projects:laura [2022/11/30 20:16] – darron | projects:laura [2024/09/02 23:21] (current) – darron | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| This project was designed to monitor the humidity of a remote location and as such has been written to support (initially) one of three humidity sensors boards, namely the DHT11, [[: | This project was designed to monitor the humidity of a remote location and as such has been written to support (initially) one of three humidity sensors boards, namely the DHT11, [[: | ||
| - | The tranmistter | + | The tranmitter |
| - | At this time, the STM32 based B-L072Z-WRLAN1 board is in active development as a sensor node. | + | A version targeting |
| - | The Raspberry Pi has can be any model with a 40 pin header if the recommeneded | + | The Raspberry Pi has can be any model with a 40 pin header if the recommended |
| ===ATMega=== | ===ATMega=== | ||
| Line 25: | Line 25: | ||
| ==Arduino== | ==Arduino== | ||
| - | For a fixed power installation an Arduino or any clone with a [[: | + | For a fixed power installation an Arduino or any clone with a [[: |
| ==Moteino== | ==Moteino== | ||
| Line 80: | Line 80: | ||
| ===STM32=== | ===STM32=== | ||
| - | Work-in-progress. | + | This documentation is work-in-progress, but fully operational code can be found below. |
| + | |||
| + | ==libopencm3 (obsolete)== | ||
| + | < | ||
| + | http:// | ||
| + | </ | ||
| + | |||
| + | ==STM32 LL== | ||
| + | < | ||
| + | http:// | ||
| + | </ | ||
| ===Raspberry Pi=== | ===Raspberry Pi=== | ||
