Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
projects:chipkit32 [2017/01/12 22:44] – external edit 127.0.0.1projects:chipkit32 [2021/10/28 02:39] (current) – [Build] darron
Line 55: Line 55:
 The breadboard firmwares are the only ones which don't require a crystal. The target device is the MX250 with the internal oscillator at 40MHz. The pin configuration is the same as the chipKIT Pi. The 9600 version operates at 9600 baud for upload rather than the standard 115200 baud. The breadboard firmwares are the only ones which don't require a crystal. The target device is the MX250 with the internal oscillator at 40MHz. The pin configuration is the same as the chipKIT Pi. The 9600 version operates at 9600 baud for upload rather than the standard 115200 baud.
  
-One difference between this firmware and the original is that the BOOTLOAD-EN button is disabled in the boot loader and instead the boot loader will to wait for a moment after reset for an upload. [[:projects:pickle|Pickle's]] `pctrl restore' may be used to reset the chip when the chipKIT Pi is attached to a RPi.+One difference between this firmware and the original is that the BOOTLOAD-EN button is disabled in the boot loader and instead the boot loader will wait a moment after reset for an upload. [[:projects:pickle|Pickle's]] `pctrl restore' may be used to reset the chip when the chipKIT Pi is attached to a RPi.
  
 === ICSP === === ICSP ===