This is an old revision of the document!
openocd -f "interface/stlink.cfg" -c "transport select hla_swd" -f "target/stm32g0x.cfg"
Open On-Chip Debugger 0.12.0-rc2+dev-00028-g9501b263e (2022-12-15-23:13)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
hla_swd
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
Info : Listening on port 6666 for tcl connections
Info : Listening on port 4444 for telnet connections
Info : clock speed 2000 kHz
Info : STLINK V2J37M27 (API v2) VID:PID 0483:374B
Info : Target voltage: 3.249836
Info : [stm32g0x.cpu] Cortex-M0+ r0p1 processor detected
Info : [stm32g0x.cpu] target has 4 breakpoints, 2 watchpoints
Info : starting gdb server for stm32g0x.cpu on 3333
Info : Listening on port 3333 for gdb connections
Info : accepting 'gdb' connection on tcp/3333
[stm32g0x.cpu] halted due to debug-request, current mode: Thread
xPSR: 0x81000000 pc: 0x080016ca msp: 0x200005a0
Info : device idcode = 0x10006467 (STM32G0B/G0Cx - Rev A : 0x1000)
Info : RDP level 0 (0xAA)
Info : flash size = 512 KiB
Info : flash mode : dual-bank
Info : device idcode = 0x10006467 (STM32G0B/G0Cx - Rev A : 0x1000)
Info : RDP level 0 (0xAA)
Info : OTP size is 1024 bytes, base address is 0x1fff7000
gdb-multiarch (gdb) set arch arm The target architecture is assumed to be arm (gdb) target extended-remote localhost:3333 Remote debugging using localhost:3333 warning: No executable has been specified and target does not support determining executable automatically. Try using the "file" command. 0x080016ca in ?? () (gdb) info reg r0 0x101337 1053495 r1 0x20 32 r2 0x0 0 r3 0x0 0 r4 0x32 50 r5 0x101328 1053480 r6 0x33 51 r7 0x3 3 r8 0xffffffff -1 r9 0xffffffff -1 r10 0xffffffff -1 r11 0xffffffff -1 r12 0xf 15 sp 0x200005a0 0x200005a0 lr 0x80016cb 134223563 pc 0x80016ca 0x80016ca xPSR 0x81000000 -2130706432 msp 0x200005a0 0x200005a0 psp 0xfffffffc 0xfffffffc primask 0x0 0 basepri 0x0 0 faultmask 0x0 0 control 0x0 0 (gdb)
