Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
interfaces:risinghf [2024/08/10 14:22] – old revision restored (2024/08/10 14:03) darron | interfaces:risinghf [2024/11/18 06:54] (current) – [Jumpers] darron | ||
---|---|---|---|
Line 9: | Line 9: | ||
This product is considered obsolete since the gateway firmware on | This product is considered obsolete since the gateway firmware on | ||
the [[boards: | the [[boards: | ||
- | compatible with modern services, however, it operates correctly | + | fully compatible with modern services, however, it is compatible |
with [[: | with [[: | ||
===Setup=== | ===Setup=== | ||
+ | * Refer to the [[https:// | ||
* Connect the ethernet to the LAN. | * Connect the ethernet to the LAN. | ||
* Power up the RisingHF daughterboard with a 1A PSU. | * Power up the RisingHF daughterboard with a 1A PSU. | ||
Line 20: | Line 21: | ||
A 2A RPi3 PSU is ideal to power the gateway. | A 2A RPi3 PSU is ideal to power the gateway. | ||
+ | ===Jumpers=== | ||
+ | |||
+ | On the NUCLEO-F746ZG board, verify the jumper settings: | ||
+ | |||
+ | < | ||
+ | JP1 (PWR-EXT) OFF | ||
+ | JP3 (power source) on VIN-5V | ||
+ | JP5 (IDD) ON | ||
+ | </ | ||
===Console=== | ===Console=== | ||
Line 157: | Line 167: | ||
===Connect=== | ===Connect=== | ||
- | [[tools: | + | [[tools: |
< | < | ||
Line 165: | Line 175: | ||
</ | </ | ||
- | ===Resources=== | + | ===Firmware=== |
- | [[https:// | + | Last known firmware for the [[:boards: |
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | |||
+ | ===Resources=== | ||
[[https:// | [[https:// | ||
+ | |||
+ | [[https:// | ||
+ | |||