Differences

This shows you the differences between two versions of the page.

--- interfaces:fs1000a [2016/02/24 16:19] – darron
+++ interfaces:fs1000a [2016/03/23 19:55] (current) – darron
@@ Line 2: / Line 2: @@
 <wrap right>
 {{:interfaces:fs1000aX2.jpg?200}}
+\\ \\
+{{:interfaces:rf-5v.jpg?200}}
 \\ \\
 {{:interfaces:fs1000a.jpg?200}}
-\\ \\
-{{:interfaces:rf-5v.jpg?200}}
 </wrap>
@@ Line 21: / Line 21: @@
 or 5V VCC.
-The digital input floats at a around -0.8V when unconnected.
+To complement the FS1000A, the RF-5V (or equivalent) exists. This receiver
+module works okay at 3V3 for short distances but is rated for 5V operation
-P.S.
+which is needed for longer distances. It would appear
+that 5V is required to operate the AGC circuit on the board. The AGC can
+produce high levels of noise on the output when no signal is broadcast from
+the FS1000A.
-The 315 MHz transmitter is not legal where I live, however, due to
+The second photo here shows the receiver. In this setup the output is
-the incompetence of one eBay seller I have one.
+fed into a cheap USB sound card whilst the FS1000A sends an AFSK signal.
+On the receiver host minimodem is used to decode the message reliably.