Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| interfaces:amba [2015/01/07 15:42] – darron | interfaces:amba [2022/07/29 01:23] (current) – [Resources] darron | ||
|---|---|---|---|
| Line 7: | Line 7: | ||
| === RPi === | === RPi === | ||
| + | |||
| + | The following guide is very old now and has mostly become obsolete. | ||
| By default, the UART is used as the Linux console, this must be disabled to allow general purpose operation. | By default, the UART is used as the Linux console, this must be disabled to allow general purpose operation. | ||
| + | |||
| + | The following script run as root can solve this. | ||
| < | < | ||
| #!/bin/sh | #!/bin/sh | ||
| C=`awk '{ for (i = 1; i <= NF; ++i) { if ($i !~ /ttyAMA0/) { printf $i" " } } printf " | C=`awk '{ for (i = 1; i <= NF; ++i) { if ($i !~ /ttyAMA0/) { printf $i" " } } printf " | ||
| echo $C > / | echo $C > / | ||
| + | sed -i ' | ||
| </ | </ | ||
| - | == / | + | High speed modes of operation are also not enabled by default and these should |
| - | High speed modes of operation are also not enabled by default and these must be enabled | + | |
| < | < | ||
| - | init_uart_clock=64000000 | + | echo "init_uart_clock=64000000" >> / |
| </ | </ | ||
| + | Reboot the RPi to apply all the settings. | ||
| + | |||
| + | ===RPi 3=== | ||
| + | |||
| + | The RPi 3 uses the UART for comms with the the built-in bluetooth module and presents a simple " | ||
| + | |||
| + | To swap the ports around to gain access to the faster port, do the following in config.txt | ||
| + | |||
| + | < | ||
| + | dtoverlay=pi3-miniuart-bt | ||
| + | </ | ||
| === Resources === | === Resources === | ||
| - | [[http:// | + | |
| + | [[http:// | ||
| [[http:// | [[http:// | ||
