Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
tools:tasmota [2023/10/17 14:03] darron [Resources] |
tools:tasmota [2023/12/15 07:56] (current) darron [SONOFF 4CH PRO R2] |
||
|---|---|---|---|
| Line 355: | Line 355: | ||
| {{tools: | {{tools: | ||
| </ | </ | ||
| - | |||
| - | First attach a console to the ESP8285. Connect a UART adapter in 3V mode to the Rx/Tx and GND pins on the board and power on with the DC input. | ||
| The built-in firmware for this device died after 6 months of use. The console shows the chip rebooting with watchdog reset errors continuously. | The built-in firmware for this device died after 6 months of use. The console shows the chip rebooting with watchdog reset errors continuously. | ||
| + | |||
| + | To upgrade attach a console to the ESP8285 by connecting a UART adapter in 3V mode to the Rx/Tx and GND pins on the board. Power up with the DC input. | ||
| To enable flash erase/ | To enable flash erase/ | ||
| Line 364: | Line 364: | ||
| ==Write flash== | ==Write flash== | ||
| - | Writing was unreliable and needed lots of attempts. | + | Writing was unreliable and needed lots of attempts |
| < | < | ||
