You are here: start » boards » rkp28sb

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
boards:rkp28sb [2016/02/17 14:14]
darron 		boards:rkp28sb [2020/12/28 12:36] (current)
Line 51: Line 51:
 5:RB3/AN4       RB3 AN9  CCP2  VPO 5:RB3/AN4       RB3 AN9  CCP2  VPO
 6:RB4/AN5       RB4 KBI0 AN11 6:RB4/AN5       RB4 KBI0 AN11
 +
 +SCK on J8 connects to LED D3
 </code> </code>
  
Line 56: Line 58:
  
 Power may be applied through the power jack or the power header. There are two LDOs and a jumper is used to select the MCU voltage between 3V3 or 5V. When applying 5V on the power header, the 3V3 LDO is still utilised so it may be selected. Power may be applied through the power jack or the power header. There are two LDOs and a jumper is used to select the MCU voltage between 3V3 or 5V. When applying 5V on the power header, the 3V3 LDO is still utilised so it may be selected.
 +
 +When using the power jack socket, the switch will turn the board on and off, as it
 +feeds the 5V LDO.
  
 There is a VUSB selection jumper which may power this pin if the PIC internal regulator is disabled. For PICs that are not USB, remove the jumper and use this a method of accessing pin 14. There is a VUSB selection jumper which may power this pin if the PIC internal regulator is disabled. For PICs that are not USB, remove the jumper and use this a method of accessing pin 14.
  
 === Resources === === Resources ===
-[[http://wiki.kewl.org/downloads/RKP28sbComponentListandInstructions.pdf|Constructors guide]]\\ +[[https://wiki.kewl.org/downloads/RKP28sbComponentListandInstructions.pdf|Constructors guide]]\\ 
-[[http://wiki.kewl.org/downloads/rkp28sbschematicshieldforpicaxe.pdf|Schematic (pdf)]] +[[https://wiki.kewl.org/downloads/rkp28sbschematicshieldforpicaxe.pdf|Schematic]]