You are here: start » boards » plus4

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
boards:plus4 [2015/02/22 22:26]
darron [Pinout] 		boards:plus4 [2021/01/04 07:47] (current)
Line 8: Line 8:
 The +4 has a number of built in I/O interfaces. These  include a serial UART, 8-bit parallel port, cassette port and a CBM IEC serial bus. The +4 has a number of built in I/O interfaces. These  include a serial UART, 8-bit parallel port, cassette port and a CBM IEC serial bus.
  
-The video output can drive composite video inputs on TVs or, for example, a Hauppauge HVR900H capture board in Linux (see photo). This setup has low latency and is very usable in Linux, but this may not be the case elsewhere.+The video output can drive composite video inputs on TVs or, for example, a Hauppauge HVR900H (2040:6600) capture board in Linux (see photo). This set up has low latency and is very usable in Linux, but this may not be the case elsewhere.
 === Pinout === === Pinout ===
  
Line 26: Line 26:
 ^Address ^Device ^Function | ^Address ^Device ^Function |
 |$FD10   |MOS 6529B  | User port P0..P7 | |$FD10   |MOS 6529B  | User port P0..P7 |
 +
 +=== Resources ===
 +
 +[[https://wiki.kewl.org/downloads/TED_7360R0_Preliminary_Data_Sheet.pdf|TED data sheet]]
 +
 +[[https://wiki.kewl.org/downloads/TED_System_Hardware_Manual.pdf|Hardware manual]]