Differences

This shows you the differences between two versions of the page.

--- boards:pico [2022/11/09 15:50]
darron
+++ boards:pico [2022/11/12 15:27] (current)
darron [Tools]
@@ Line 1: / Line 1: @@
+====Raspberry Pi PICO====
 <wrap right>
-{{:boards:pipico.jpg?200}}
+{{:boards:pipico.jpg?100}}
 \\ \\
-{{:boards:four_picos.jpg?200}}
+{{:boards:four_picos.jpg?100}}
 </wrap>
-===Segger J-Link===
+Dual core Arm Cortex M0 microcontroller designed to run MicroPython.
+There are four varieties of this board produced by RPi. The differences
+are whether they come pre-installed with header pins and a debug socket
+and if they have a WiFi adapter on board.
+===Tools===
+Read this [[https://datasheets.raspberrypi.com/pico/getting-started-with-pico.pdf|guide]]. Within
+is the setup procedure for development tools is as follows:
+<code>
+wget https://raw.githubusercontent.com/raspberrypi/pico-setup/master/pico_setup.sh
+sh pico_setup.sh
+</code>
+This will install the ARM compiler, OpenOCD, the SDK, examples, and various other things.
+OpenOCD is built from source with the following options:
+<code>
+./configure --enable-ftdi --enable-sysfsgpio --enable-bcm2835gpio --enable-picoprobe
+</code>
+===J-Link===
 <wrap right>
 {{:boards:pico-segger.jpg?200}}
 </wrap>
+Segger J-Link can be use to interact with the PICO via the debug port.
 ==CORE 0==
@@ Line 94: / Line 119: @@
 Cortex-M0 identified.
 </code>
+===Resources===
 https://github.com/raspberrypi/pico-sdk
 https://github.com/raspberrypi/pico-examples
 https://wiki.segger.com/Raspberry_Pi_Pico