You are here: start » boards » demov1

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
boards:demov1 [2022/11/13 13:29]
darron 		boards:demov1 [2022/11/14 00:02]
darron [Test]
Line 5: Line 5:
 {{:boards:demov1-test.jpg?200|J-Link test with J-Link EDU Mini}} {{:boards:demov1-test.jpg?200|J-Link test with J-Link EDU Mini}}
 \\ \\ \\ \\
-{{:boards:demov1-test2.jpg?200|OpenOCD test with J-Link CLONE}}+{{:boards:demov1-test3.jpg?200|OpenOCD test with J-Link CLONE}}
 \\ \\ \\ \\
 {{boards:stm32f030.png?200|Pinout}} {{boards:stm32f030.png?200|Pinout}}
Line 67: Line 67:
 pin and provide a pulse for testing STM32 EXTI. pin and provide a pulse for testing STM32 EXTI.
  
-For programming, use [[tools:segger|J-Link]] device or [[tools:openocd|OpenOCD]].+For programming, use [[tools:segger|J-Link]] or [[tools:openocd|OpenOCD]].
  
 ==Wiring== ==Wiring==
Line 98: Line 98:
  
 From the RS232 perspective RTS is inverted so when picocom takes From the RS232 perspective RTS is inverted so when picocom takes
-the line is low, it's actually a high logical output and the board+the line low, it's actually a high logical output and the board
 is taken out of reset. is taken out of reset.
  
 ==Reset== ==Reset==
  
-CTRL A CTRL G will toggle the RTS line state.+Picocom CTRL A CTRL G will toggle the RTS line state.
  
 ==Reboot== ==Reboot==
Line 116: Line 116:
 ==Pulse== ==Pulse==
  
-CTRL A CTRL P will pulse the DTR pin from low to high for+Picocom CTRL A CTRL P will pulse the DTR pin from low to high for
 1 second to test EXTI high or low edge. 1 second to test EXTI high or low edge.