You are here: start » boards » demov1

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
boards:demov1 [2022/11/13 13:24]
darron [Power] 		boards:demov1 [2022/11/14 00:02]
darron [Test]
Line 5: Line 5:
 {{:boards:demov1-test.jpg?200|J-Link test with J-Link EDU Mini}} {{:boards:demov1-test.jpg?200|J-Link test with J-Link EDU Mini}}
 \\ \\ \\ \\
-{{:boards:demov1-test2.jpg?200|OpenOCD test with J-Link CLONE}}+{{:boards:demov1-test3.jpg?200|OpenOCD test with J-Link CLONE}}
 \\ \\ \\ \\
 {{boards:stm32f030.png?200|Pinout}} {{boards:stm32f030.png?200|Pinout}}
Line 61: Line 61:
 The USB socket does not support I/O, it's only for powering the device. The USB socket does not support I/O, it's only for powering the device.
  
-=== Setup ===+=== Test ===
  
 For testing this board use a [[interfaces:ftdi|UM232R]] for power, serial comms, For testing this board use a [[interfaces:ftdi|UM232R]] for power, serial comms,
Line 67: Line 67:
 pin and provide a pulse for testing STM32 EXTI. pin and provide a pulse for testing STM32 EXTI.
  
-For programming, use [[tools:segger|J-Link]] device or [[tools:openocd|OpenOCD]].+For programming, use [[tools:segger|J-Link]] or [[tools:openocd|OpenOCD]].
  
 ==Wiring== ==Wiring==
Line 97: Line 97:
 </code> </code>
  
-==Reset==+From the RS232 perspective RTS is inverted so when picocom takes 
 +the line low, it's actually a high logical output and the board 
 +is taken out of reset.
  
-CTRL A CTRL G will change the RTS line state from high to low +==Reset==
-to alter the reset line.+
  
-From the RS232 perspective it's inverted so when picocom says +Picocom CTRL A CTRL G will toggle the RTS line state.
-the line is low, it's actually a high output and the device +
-is out of reset.+
  
 ==Reboot== ==Reboot==
Line 117: Line 116:
 ==Pulse== ==Pulse==
  
-CTRL A CTRL P will pulse the DTR pin from low to high for+Picocom CTRL A CTRL P will pulse the DTR pin from low to high for
 1 second to test EXTI high or low edge. 1 second to test EXTI high or low edge.
  
-=== Test ===+=== Programming ===
  
-Test SWD with J-Link and OpenOCD.+Use SWD with J-Link or OpenOCD.
  
 ==J-Link== ==J-Link==