You are here: start » projects » winklepicker

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
projects:winklepicker [2017/02/18 00:49]
darron [Operation] 		projects:winklepicker [2017/02/22 22:26]
darron [Winklepicker Reset Controller]
Line 4: Line 4:
 </wrap> </wrap>
  
-Winklepicker Reset Controller is a RS232 BREAK detector using either a PIC12F1501 or PIC12F1571 micro-controller.+Winklepicker Reset Controller is a RS232 BREAK detector using either a PIC12F1501 or PIC12F1571 microcontroller.
  
-It has been designed specifically for the [[:projects:oxford|Oxford]] and [[:projects:wellington|Wellington]] boot loaders and it works in conjunction with the [[:projects:easyloader|Easy-loader]] firmware upload utility.+It has been designed specifically for the [[:projects:cowboy|Cowboy]], [[:projects:oxford|Oxford]] and [[:projects:wellington|Wellington]] boot loaders and it works in conjunction with the [[:projects:easyloader|Easy-loader]] firmware upload utility.
 === Licence === === Licence ===
  
Line 35: Line 35:
 Routing is enabled when RTS is low during a BREAK condition and disabled when RTS is high during a BREAK condition. Routing is enabled when RTS is low during a BREAK condition and disabled when RTS is high during a BREAK condition.
  
-This mode can be used to simply reset the device or allow fine grained control of the reset pin for ICSP.+This mode can be used to simply reset the device or allow fine grained control of the reset pin for ICSP. It has also been designed to allow RTS to perform regular serial duties when not routed through to the target reset pin.
  
 === Demonstration === === Demonstration ===