You are here: start » projects » nanu-nanu

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
projects:nanu-nanu [2015/05/07 12:06]
darron [Set up] 		projects:nanu-nanu [2017/02/20 01:53]
darron [Credits and thanks]
Line 14: Line 14:
 </wrap> </wrap>
  
-Nanu nanu is Microchip PIC32MX ICSP for the Arduino.+This is a Microchip PIC32 ICSP (in circuit serial programmer) for AVR micro-controllers. Nanu nanu allows an AVR to program the flash on a PIC32. 
  
 It has been developed specifically for [[:boards:nano|Arduino Nano 3.0]] clones with CH340G UARTs and [[:boards:mini|Arduino Pro Mini]] clones but will work with any AVR based Arduino clone such as the [[:boards:rkat28sb|RKAT28sb]]. It has been developed specifically for [[:boards:nano|Arduino Nano 3.0]] clones with CH340G UARTs and [[:boards:mini|Arduino Pro Mini]] clones but will work with any AVR based Arduino clone such as the [[:boards:rkat28sb|RKAT28sb]].
Line 25: Line 25:
 === Credits and thanks === === Credits and thanks ===
  
-This software was written by Darron M Broad and is an adaptation of [[:projects:pickle|Pickle Microchip PIC ICSP]].+This software was written in December 2014 by Darron M Broad and is an adaptation of [[:projects:pickle|Pickle Microchip PIC ICSP]].
  
-This project was inspired by the retrobsd forum post by R. Rozee.+This project was inspired by a retrobsd forum post by Robert Rozee where it was  used to demonstrate programming a PIC32 using ICSP with pic32prog.
  
 === Install === === Install ===