You are here: start » projects » k8048-rpi

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
projects:k8048-rpi [2020/08/05 17:45]
darron [Pickle Microchip PIC ICSP] 		projects:k8048-rpi [2020/08/16 04:44] (current)
darron [Velleman K8048 interface]
Line 1: Line 1:
 ==== Velleman K8048 interface ==== ==== Velleman K8048 interface ====
  
-We may attach the Velleman K8048 kit to the RPi via a simple interface circuit. This allows us to perform high voltage programmer and basic experiments.+We may attach the Velleman K8048 kit to the RPi via a simple interface circuit. This allows us to perform high voltage programming and basic experiments.
  
 ===  GPIO configuration === ===  GPIO configuration ===
Line 69: Line 69:
 === Stripboard layout === === Stripboard layout ===
  
-{{:boards:rpi:layout_top.jpg|TOP}} {{:boards:rpi:layout_bottom.jpg|BOTTOM}}+{{:projects:k8048-rpi:layout_top.jpg|TOP}} {{:projects:k8048-rpi:layout_bottom.jpg|BOTTOM}}
  
 On the left we have the component side and to the right the solder (strip) side.\\ On the left we have the component side and to the right the solder (strip) side.\\
Line 76: Line 76:
 == Components == == Components ==
  
-{{:boards:rpi:components.jpg?256}} +{{:projects:k8048-rpi:components.jpg?256}} 
  
 The serial header above is a standard P.C. motherboard header.\\ The serial header above is a standard P.C. motherboard header.\\
Line 83: Line 83:
 == Assembled == == Assembled ==
  
-{{:boards:rpi:interface1.jpg?256}} {{:boards:rpi:interface2.jpg?256}}+{{:projects:k8048-rpi:interface1.jpg?256}} {{:projects:k8048-rpi:interface2.jpg?256}}
  
 Wire links are cut from CW1308 telephone cable.\\ Wire links are cut from CW1308 telephone cable.\\
 The finished article has a corner trimmed to fit the R-PI case.\\ The finished article has a corner trimmed to fit the R-PI case.\\
  
-{{:boards:rpi:pulldown.jpg?256}}+{{:projects:k8048-rpi:pulldown.jpg?256}}
  
 You may wire a pull-down resistor to IC pin 4/5 to GND to stop stray noise pickup when the Velleman K8048 is disconnected. This isn't needed for normal and connected operation. You may wire a pull-down resistor to IC pin 4/5 to GND to stop stray noise pickup when the Velleman K8048 is disconnected. This isn't needed for normal and connected operation.
Line 110: Line 110:
 == In operation == == In operation ==
  
-{{:boards:rpi:interface3.jpg?256}}+{{:projects:k8048-rpi:interface3.jpg?256}}
  
 The RPi queries the PICMicro to reveal that it's a PIC16F648A. The RPi queries the PICMicro to reveal that it's a PIC16F648A.
  
 This serial header is a longer example than the one shown above but works just as well. The maximum possible length is unknown. This serial header is a longer example than the one shown above but works just as well. The maximum possible length is unknown.
 +