You are here: start » projects » hi-pi

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
projects:hi-pi [2015/03/11 00:34]
darron [Hi-Pi high voltage PIC programmer] 		projects:hi-pi [2017/03/23 05:34] (current)
darron [Appendix]
Line 9: Line 9:
 Low voltage programming in-circuit is preferable but a high voltage programmer Low voltage programming in-circuit is preferable but a high voltage programmer
 is sometimes a requirement for older parts which offer no low voltage mode, or is sometimes a requirement for older parts which offer no low voltage mode, or
-to reset a device which has low voltage programming mode disabled in it's+to reset a device which has low voltage programming mode disabled in its
 configuration bits. configuration bits.
 +
 +=== News ===
 +
 +A bug may occur with this circuit in certain situations, please refer to the
 +appendix.
 +
  
 === Schematic === === Schematic ===
Line 23: Line 29:
 {{:projects:hi-pi.png?200}} {{:projects:hi-pi.png?200}}
  
-The TELCOM driver will produce something close to 15V on it's output when activated, it's important to be careful with wiring here and appreciate that this is dangerous voltage for something like a Raspberry Pi. Be careful when connecting the input pin. +The TELCOM driver will produce something close to 15V on its output when activated, it's important to be careful with wiring here and appreciate that this is a dangerous voltage for something like a Raspberry Pi. Be careful when connecting the input pin.
  
 +Note: This is version 1 of Hi-Pi, version 2 will appear here later which will add some small improvements.
 === Pickle Microchip PIC ICSP === === Pickle Microchip PIC ICSP ===
  
Line 48: Line 54:
 PGDI=6 PGDI=6
 # PGM # PGM
-PGM=255+PGM=-1
 </code> </code>
  
Line 113: Line 119:
  
 Because this is an out of circuit programmer, we will now need to remove Because this is an out of circuit programmer, we will now need to remove
-the chip from the it's programming station and place it in-circuit to+the chip from its programming station and place it in-circuit to
 operate. operate.
 +
 +=== Appendix ===
 +
 +Thanks must go to Tomas Lorenc who has notified me a fix is required
 +for devices which have MCLR configured as an I/O. In this situation
 +a device is not brought out of reset and into programming mode due to VDD
 +being raised first. Here he presents a fix for this situation.
 +
 +{{:projects:hi-pi-mod.png?200}}
 +
 +For example, the PIC12F675 has this feature in it's configuration word.
 +
 +<code>
 +bit5
 +MCLRE: GP3/MCLR Pin Function Select bit(5)
 +1 = GP3/MCLR pin function is MCLR
 +0 = GP3/MCLR pin function is digital I/O, MCLR internally tied to VDD
 +</code>
 +
 +