You are here: start » projects » easyloader

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Last revision Both sides next revision
projects:easyloader [2017/03/12 02:03]
darron [Usage] 		projects:easyloader [2020/10/20 13:38]
darron [Example]
Line 30: Line 30:
  
 Options: Options:
- -a   arduino (DTR + CAP) reset + -a     arduino (DTR + CAP) reset 
- -b N use TTY baud rate N + -b N   use TTY baud rate N 
- -d   hang up DTR after serial port open + -d     hang up DTR after serial port open 
- -e   read EEPROM + -e     read EEPROM 
- -f   read flash + -f     read flash 
- -h   HELLO only + -h     HELLO only 
- -i N use CAN bus message id N + -i N   use CAN bus message id N 
- -k N send BRK for N ms after serial port open + -k N   send BRK for N ms after serial port open 
- -l   log serial input to stdout when done + -l H|R log serial input when done (H = hex, R = raw) 
- -n   do not run firmware on exit + -n     do not run firmware on exit 
- -p   run pickle pctrl to reset device + -p     run pickle pctrl to reset device 
- -q   quiet erase/write + -q     quiet erase/write 
- -r   hang up RTS after serial port open + -r     hang up RTS after serial port open 
- -s   simulate erase/write + -s     simulate erase/write 
- -t   time to wait in ms after serial port open + -t     time to wait in ms after serial port open 
- -v   verify + -v     verify 
- -w N winklepicker mode N (1 or 2) reset + -w N   winklepicker mode N (1 or 2) reset 
- -x   drain serial output after each transmitted byte + -x     drain serial output after each transmitted byte 
- -z A erase page at address A+ -z A   erase page at address A
  
 Version: 4 Version: 4
Line 54: Line 54:
  
 The device can either be a serial interface of CAN Bus interface. Support for The device can either be a serial interface of CAN Bus interface. Support for
-CAN Bus is boot loader dependent and is only available for Wellington boot loader at present.+CAN Bus is platform and boot loader dependent and is only available for Linux and the Wellington boot loader at present.
  
 === Example === === Example ===
  
-Here a device attached to RPi is first reset using `pctrl restore' and the+Here a device which is attached to an RPi is first reset using `pctrl restore' and after
 a hex file image is uploaded at 57600 baud. a hex file image is uploaded at 57600 baud.