You are here: start » interfaces » usbasp

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
interfaces:usbasp [2014/12/20 20:06]
darron 		interfaces:usbasp [2021/09/13 13:20] (current)
darron
Line 2: Line 2:
 <wrap right> <wrap right>
 {{:interfaces:usbasp.jpg?200}} {{:interfaces:usbasp.jpg?200}}
 +\\ \\
 +{{:interfaces:usbasp2.jpg?200}}
 </wrap> </wrap>
  
Line 8: Line 10:
 This is a cheap programmer. This is a cheap programmer.
  
-=== Linux ====+Some boards contain jumpers to disable power delivery to the 
 +target device, otherwise they always supply power. 
 + 
 +=== Linux ===
  
 == udev == == udev ==
 <code> <code>
-SUBSYSTEMS=="usb",ATTRS{idVendor}=="16c0",ATTRS{idProduct}=="05dc",\+SUBSYSTEMS=="usb",\ 
 +    ATTRS{idVendor}=="16c0",\ 
 +    ATTRS{idProduct}=="05dc",\
     MODE:="0666"     MODE:="0666"
 +</code>
 +
 +== Update firmware ===
 +
 +Generic USBASP comes with an old firmware, you can upgrade it using a USBtiny like this
 +<code>
 +avrdude -c usbtiny -p atmega8 -e -U flash:w:usbasp.atmega8.2011-05-28.hex
 +
 </code> </code>
  
 == Program == == Program ==
 <code> <code>
-avrdude -c usbasp ...+$ avrdude -c usbasp -B 5 -p m328p -D 
 + 
 +avrdude: set SCK frequency to 187500 Hz 
 +avrdude: AVR device initialized and ready to accept instructions 
 + 
 +Reading | ################################################## | 100% 0.01s 
 + 
 +avrdude: Device signature = 0x1e950f (probably m328p) 
 + 
 +avrdude: safemode: Fuses OK (E:FD, H:DA, L:FF) 
 + 
 +avrdude done.  Thank you.
 </code> </code>
 +
 +=== Resources ===
 +
 +[[https://www.fischl.de/usbasp/|Project page]]
 +
 +[[http://www.fischl.de/usbasp/bilder/usbasp_circuit.png|Schematic]]
 +
 +[[http://www.fischl.de/usbasp/usbasp.2011-05-28.tar.gz|Updated firmware]]
 +
 +