You are here: start » interfaces » amba

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
interfaces:amba [2015/02/25 03:27]
darron [RPi] 		interfaces:amba [2022/07/29 01:23] (current)
darron [Resources]
Line 7: Line 7:
  
 === RPi === === RPi ===
 +
 +The following guide is very old now and has mostly become obsolete.
  
 By default, the UART is used as the Linux console, this must be disabled to allow general purpose operation. By default, the UART is used as the Linux console, this must be disabled to allow general purpose operation.
Line 24: Line 26:
  
 Reboot the RPi to apply all the settings. Reboot the RPi to apply all the settings.
 +
 +===RPi 3===
 +
 +The RPi 3 uses the UART for comms with the the built-in bluetooth module and presents a simple "mini-uart" on the regular pins.
 +
 +To swap the ports around to gain access to the faster port, do the following in config.txt
 +
 +<code>
 +dtoverlay=pi3-miniuart-bt
 +</code>
 === Resources === === Resources ===
-[[http://infocenter.arm.com/help/topic/com.arm.doc.ddi0183f/DDI0183.pdf|Manual]]\\+ 
 +[[http://infocenter.arm.com/help/topic/com.arm.doc.ddi0183f/DDI0183.pdf|Manual]] 
 [[http://www.raspberrypi.org/wp-content/uploads/2012/02/BCM2835-ARM-Peripherals.pdf|Peripherals]] [[http://www.raspberrypi.org/wp-content/uploads/2012/02/BCM2835-ARM-Peripherals.pdf|Peripherals]]