==== 1wire bus ====
<wrap right>
{{:interfaces:1wire.jpg?200}}
\\ \\
{{:interfaces:1wire-2.jpg?200}}
\\ \\
{{:interfaces:keyes.jpg?200}}
</wrap>

The 1wire bus supports various low speed digital devices and is supported in Linux on the Raspberry Pi.

=== Raspberry Pi ===

Edit boot/config.txt to assign gpio4 for 1wire.
<code>
dtoverlay=w1-gpio,gpiopin=4
</code>

Reboot and after load driver.
<code>
modprobe w1_gpio
</code>

These are the GPIO header pin assignments for the 1 wire bus.

^Pin ^Name  ^Function |
| 1  | 3V3 | POWER|
| 6  | GND| GROUND |
| 7  | GPIO4 | DATA|

The relevant pins on the Pi header are as follows.
<code>
                +---P1---+
3V3             01      02 5V
GPIO0/GPIO2     03 A/A+ 04 5V
GPIO1/GPIO3     05 B/B+ 06 GND
GPIO4           07 2    08 GPIO14/TX
                ..      ..
</code>

NB. The 1 wire data line must pulled high via 4K7 to 3V3 power.


=== DS18B20 Thermometer ===
<code>
+-------+
| 1 2 3 |
+-------+
  | | |
  | | |
  
1 GROUND
2 DATA
3 POWER
</code>

<code>
modprobe w1_therm
cat /sys/bus/w1/devices/28-041460bdd6ff/w1_slave 
8f 01 55 00 7f ff 0c 10 a0 : crc=a0 YES
8f 01 55 00 7f ff 0c 10 a0 t=24937
</code>

=== KEYES KY-001 DS18B20 module ===

This module re-orders the pins so beware.

<code>
+-------+
|DS18B20|
|       |
+-G R Y-+
  | | |
  
G GROUND
R POWER
Y DATA
</code>

DATA is pulled up via a 4K7 resistor and an LED. The LED will flash
during communication with the chip.
=== DS2431 EEPROM ===
<code>
+-------+
| 1 2 3 |
+-------+
  | | |
  | | |
  
1 GROUND
2 DATA
3 NC
</code>

<code>
modprobe w1_ds2431
echo "hello world" > /sys/bus/w1/devices/2d-00000de5d608/eeprom
cat /sys/bus/w1/devices/2d-00000de5d608/eeprom
hello world
</code>

=== Resources ===
[[https://datasheets.maximintegrated.com/en/ds/DS18B20.pdf|DS18B20 Thermometer]]\\
[[https://datasheets.maximintegrated.com/en/ds/DS2431.pdf|DS2431 EEPROM]]